ModMyMods USB 3.0 20-Pin to Dual Type-A Extension Cable with Panel Mounts (CAB248)

This cable brings a USB 3.0 header of the motherboard out to two USB 3.0 Type-A ports on a small screw-mount panel. The blue 20-pin connector plugs onto the internal USB 3.0 header, and the panel with the two female Type-A ports can be screwed into a case panel, a bracket, a desk or a custom build. The two black cables are about 50 cm long, so the ports can sit almost anywhere in or on the case.

Properties

Type

Internal USB 3.0 header to panel mount cable

Motherboard end

USB 3.0 20-pin header connector, female

Ports

2x USB 3.0 Type-A female on a screw-mount panel

Length

About 50 cm

Pieces in the pack

1

Two extra USB 3.0 ports from one header

A USB 3.0 motherboard header carries two USB ports. This cable turns them into two full size Type-A ports on a compact panel, for example on a test bench, in a custom front panel, on a desk or anywhere the case has no front USB ports.

Panel with screw ears

The black panel holds both ports side by side and has a screw ear with a hole on each side, so it can be fixed with two screws. The holes are 48 mm apart.

Blue USB 3.0 connector

The motherboard end is the standard blue USB 3.0 header connector with a key, so it fits the header only the right way round.

Technical data

Notes

• Both ports share the one USB 3.0 header they are connected to.

In the box

• 1x ModMyMods USB 3.0 20-Pin to Dual Type-A Extension Cable with Panel Mounts