Details
Thermal Grizzly's PhaseSheet PTM Pro is a thermal pad based on a phase change material (PCM), here as one 40 x 40 mm sheet, 0.2 mm thick. It is the further development of the PhaseSheet PTM, with higher thermal conductivity and a new carrier film, and its primary application is on processors and graphics chips, where it takes the place of thermal paste.
Properties
- Size
- 40 x 40 mm
- Thickness
- 0.2 mm
- Material
- Phase change material (PCM)
- Electrically conductive
- No
- Phase change temperature
- 45°C
- Operating temperature
- -40°C to +125°C
- Density
- 2.6 g/cm³
- Color
- Gray
What the Pro changes
Thermal Grizzly reworked the composition of the material for improved thermal conductivity compared to the PhaseSheet PTM. Together with a new carrier film, this also makes the Pro easier to handle: the film comes off both sides very easily, which significantly reduces the risk of tearing the sheet.
Solid in the hand, liquid under load
At room temperature the phase change material is solid, so the sheet can be easily applied. It only begins to liquefy above 45°C, and during operation it transfers heat effectively like a thermal paste. In its liquid state it keeps a very low viscosity. A mounting force of around 300 to 400 N is required for optimal distribution of the liquefied material and the thinnest possible interface layer, and the low starting thickness of 0.2 mm keeps the heat transfer path short. The sheet is electrically non-conductive and can therefore be used in a wide range of applications.
Thermal Grizzly's short list of its strengths:
- Excellent thermal conductivity
- Consistently high performance
- Very long service life
- Versatile applications
- Electrically non-conductive
- Easy to use
The pump-out effect
Under operating temperatures the heat spreader and the base plate of a CPU cooler, for example, deform and become concave or convex, then return to their original flat shape as they cool down. As a result, thermal paste is gradually forced out from between the two. The effect is particularly pronounced with a copper cooler on a graphics chip, because silicon and copper expand at different rates when heated. PhaseSheet PTM Pro contracts again as it solidifies, which keeps the pump-out effect to a minimum and supports consistent heat transfer. Thermal Grizzly's data sheet names replacing the thermal paste on older graphics cards and converting to water cooling as typical applications.
Service life and break-in
Thermal Grizzly has optimized the sheet for applications with long maintenance intervals. It offers a longer service life than traditional thermal pastes, but not the longevity of KryoSheet, which is virtually maintenance-free. Its maximum thermal conductivity develops and stabilizes after around ten thermal cycles, each reaching temperatures above 60°C.
Before you install it
- Completely remove the carrier films from both sides before installation.
- Follow the installation instructions of the respective hardware and cooler manufacturers.
In the box
- 1x PhaseSheet PTM Pro, 40 x 40 x 0.2 mm
Thermal Grizzly's data sheet and safety data sheet are both PDFs.








