Details
Tired of feeble plastic mixing wands that bend and break while you spread your thermal paste? This reusable thermal paste mixing wand is made of solid stainless steel and will not break under standard or extreme thermal paste application. It is 12 cm long, with a flat spatula end and a ribbed grip.
Properties
- Type
- Thermal paste spreader and mixing wand
- Material
- Stainless steel
- Length
- 12 cm
- Tip
- Flat spatula
- Reusable
- Yes
- Pieces in the pack
- 1
Spread paste evenly
The flat spatula end spreads thermal paste in a thin, even layer over a CPU or GPU and pulls a stripe of paste across a large heat spreader. It also stirs paste that has separated in the syringe or tub, and mixes two-part thermal epoxy.
Solid stainless steel
The wand is a single piece of stainless steel. It does not flex like a plastic card or spatula, it does not break, and the paste does not soak into it.
Use it again and again
Wipe the wand clean with a paper towel and a little isopropyl alcohol after use and it is ready for the next build.
Sure grip
A ribbed section in the middle of the handle gives your fingers a good hold, and the rounded end sits comfortably in the hand.
Technical data
| Part number | BT-SSW |
| Type | Thermal paste mixing wand |
| Material | Stainless steel |
| Length | 12 cm |
| Tip | Flat spatula |
| Color | Stainless steel |
Notes
- Each order quantity is one wand. The picture shows two wands.
- Steel is harder than a bare die. Spread paste on a bare GPU or CPU die gently, without scraping.
In the box
- 1x Stainless Steel Reusable Thermal Paste Mixing Wand
