Details
The latest addition to the ModMyMods product line, our ModClamps are the perfect addition to any system with unruly tube runs. With their dual opening design, these clamps will allow you to keep your flexible tube runs parallel, add additional support to otherwise floppy tube runs, and add a beautifully clean aesthetic to any water cooled system. Made from Aluminum and anodized black, our ModClamps are sure to please the eye while being a sturdy and reliable management solution. Please note that the Aluminum does not come in contact with coolant making these compatible in any loop.
Available in multiple sizes to accommodate the most common tubing sizes used in PC water cooling. Please match the outer diameter of your tubing to the corresponding clamp size. These clamps are compatible with both flexible as well as rigid style tubes.
All clamps come with an optional foam layer that can be installed on the inside of the clamp. Simply cut the provided strip into 4 pieces and apply them to the inside of the clamps on both sides. This both offers an additional layer of protection between the clamps and your tube to prevent scratches, as well as provides additional wiggle room to accommodate tubing with slightly different diameter tolerances.
To install, simply remove the central set screw and separate the clamp into it's two halves. Place both halves around the 2 tubes to be managed, and secure the halves back together by replacing that set screw.
