ModMyMods Male to Male Addressable RGB Connector (MOD-0285)

This small male to male connector turns a female 3-pin addressable RGB (ARGB) plug into a male one. It holds three pins in a four-position black plastic carrier, one position left empty as on the 3-pin ARGB plug, with straight pins on both sides: push one side into a female addressable RGB connector and the other side becomes a male plug, without cutting, crimping or soldering, and without any permanent change to the cable.

Properties

Type

3-pin addressable RGB (ARGB) male to male connector

Pins

3, in a four-position carrier

Fits

3-pin female addressable RGB connectors

Pieces in the pack

1

Join two female ends

Many addressable RGB cables, LED strips, fans and splitters end in a female connector, and so do the ModMyMods extension and splitter cables. Put this connector between two female ends to join them, for example to connect a lighting part with a female plug to a female extension or splitter cable.

Nothing permanent

The connector only pushes in. Pull it out again and the cable is back to its original female end.

Compatibility

The connector fits any 3-pin 5V addressable (digital) RGB connection: ARGB headers of motherboards, ARGB controllers, LED strips, fans and other ARGB lighting.

Part of a matched set

ModMyMods makes 3-pin addressable RGB (ARGB) extension cables in 30 cm and 50 cm, 2-way, 3-way and 4-way splitter cables and a male to male connector, all in black with the same connectors, so they can be combined in one build.

Technical data

Notes

• Line up the arrow marks of both female connectors when you join them, so each line meets its partner.
• 3-pin addressable RGB (ARGB) and 4-pin RGB connections are different systems; plug ARGB parts only into 5V 3-pin ARGB headers.

In the box

• 1x ModMyMods Male to Male Addressable RGB Connector