ModMyMods 2-Pin Motherboard Power/Reset Switch Internal Header Cable - 45cm (CAB062)

This ModMyMods switch cable puts a push button on a 45 cm cable with a 2-pin connector for the power or reset header of the motherboard. Use it to start a test bench or open frame build, to replace a broken case button, or to add a reset button where the case has none.

Properties

Type

Motherboard power/reset switch cable

Connector

2-pin, marked POWER SW

Switch

Push button

Length

45 cm

Wires

Red and black

Pieces in the pack

1

Power or reset

Plug the 2-pin connector onto the power switch pins of the front panel header to use the button as a power button, or onto the reset pins to use it as a reset button. The connector is marked POWER SW.

Room to place it

With 45 cm of cable, the button reaches the edge of a test bench, a desk or a custom mounting point away from the motherboard. The red and black wires are easy to route.

Technical data

Notes

• Check the front panel pin layout in the manual of your motherboard before you connect the cable.

In the box

• 1x 2-Pin Motherboard Power/Reset Switch Internal Header Cable - 45cm