The aquaduct 360 eco + Mark II is the combination of high quality components with very good performance at a reasonable price. Main objectives of the development were, a convincing design and a cooling capacity that sets standards at a very good price-performance ratio. All this was achieved with the aquaduct eco series. It is very easy to handle, secure and extremely compact.
Name-donor element is a kind of bridge over which the water runs and then falls on the other side. The aquaduct is a combination of passive and active radiator, which combine the advantages of both technologies in a single product. To make the aquaduct as easy to maintain as possible, large water tanks were integrated into the passive cooling profiles. This minimizes necessity of the water refilling to the annual maintenance.
The aquaduct 360 eco + Mark II includes a microprocessor-controlled 12 V pump, a triple-radiator and tailored to the specific requirements of the external water cooling control electronics. The free aquasuite 2012 Software allows intuitive configuration and monitoring of the aquaduct.
With integrated advanced control and monitoring electronics and the internal fan are monitored and controlled in addition to the pump. A determination is also the water temperature, air temperature and the internal electronics temperature of the aquaduct.
For fan control several control modes are available. For example, can be controlled to a desired temperature of the water out. The fan then remain off (passive mode) until this temperature is reached. We exceeded the target temperature, the microcontroller starts the fan and controls by elaborate controls on the minimum essentials one speed. But it is also possible to configure the fan to a speed or voltage.
For installation in a PC PCI (e) -Slot blank faceplate is. About this is the aquaduct power. To supply the circuit board a free power supply plug of the PC power supply is needed.
A speed signal output with artificially-generated speedometer signal, it also allows for. B. on the BIOS of the motherboard to implement an emergency shutdown of the PC.
In addition, two cutouts allow in the slot bracket easy carry of the plug & cool water hoses into the case interior.
The electronics of the Eco + series also allows the connection of an external flow sensor to the aquaduct. This can be installed in the PC and connected to the slot bracket. It then can be placed in the aquasuite appropriate warning levels for the alarm and the flow can be monitored graphically.
In the case of an alarm (user configurable) can be issued a warning tone from the instrument. In addition, the PC can be switched off via the speed signal. The alarm evaluation is extensive and of course also contains a temperature and fan monitoring.
|Fulfillment||Ships in 3-5 Business Days|
|Pump type||Integrated Pump|
|Included||Aquaduct 360 eco + mark II external water cooling (fully assembled) </br>
two connections plug & cool straight (mounted on the unit) </br>
PCIe slot bracket with board </br>
Connection cable aquaduct to slot bracket (length approx 2 m) </br>
USB connection cable (length approx 2 m) </br>
plug & cool tube in-and return (length approx 2 m) </br>
Coolant DP Ultra (1000 ml) </br></br>
Note: CPU Block not included!